Atomium™ Max Mgsb - Transmission & Gearbox Oil

Compound MAX MGSB creates conditions under which the friction surfaces in a gearbox parts are covered with a metallic protective layer, which has a special structure. This layer partially restores the dimensions and geometry of worn parts, optimizes gaps in friction pairs, keeps more oil on the friction surfaces.

This allows to:

• facilitate gearshift. Optimization of gaps, retention of a denser oil layer on the surfaces of gearing provide the correct gearshift;
• reduce noise and vibration levels. Optimization of gaps and restoration of the optimum spacing in bearings reduce noise and vibration during operation of the unit;
• increase the vehicle free run (in neutral gear). Retention of denser oil layer on the surface reduces the frictional losses and increases free run: movement the car in neutral gear.
• protect the gearbox against wear. Protective layer on the friction surfaces and dense oil layer substantially reduces wear and increases the lifetime of the unit.

Tribotechnical compound «MAX MGSB» is applied in one stage in accordance with the following procedure:

1. Warm up the gearbox up to operating temperature (regular operation).
2. Stop the engine
3. Stir and shake the can thoroughly until natural sediments (active components) are totally dissolved.
4. Fill in compound through the unit's regular oil filling neck at the rate 10 ml of the compound per 1 quart of transmission oil.
5. After applying the engine should run (it is recommended to drive the vehicle) for no less than 20 - 25 min. in mode of regular operation.

After the procedure you can use the vehicle as usual.

Please check my listing for heavy duty engine oil additive: https://www.ebay.com/itm/255994519486